Actually learning how to hand stitch a quilt is very simple as long as you know the simple techniques I’m going to reveal in this article.
Since you now have the set of tools you require to know how to hand stitch a quilt including a thimble, quilting thread, quilt frame or hoop and most certainly the quilt or fabric, you are good to go.
Make up your mind regarding the place you will begin the quilting stitches. As soon as you figure this out, bury the needle you are using approximately 1 inch away from your desired starting point.
Put the needle in between the quilt layers and bring its point upwards, exactly where you desire to start quilting. (The main objective here is burying the knot in the quilt layers.)
To have amazing results regarding how to hand stitch a quilt, the needle ought to be pulled all through the top region of the quilt then give it a moderate tug. The thread’s knot ought to slide right through the middle of the quilt. But, if this does not happen just try playing with it. Occasionally, I tug the thread using my fingers as I secure the fabric using the needle. If the knot is tiny, it is certain to go through the quilt fabric’s weave.
Look at the thread’s end past the formed knot. If the end of the thread still sticks up through the tip of the quilt, it might be important for you to work it onto the quilt layers. This can simply be done using your needle.
Poke the needle lightly through the top of the quilt, slightly on top of the thread. Of course, I am aware that it is impossible for you to see this because it is usually covered by the fabric. However, you can feel the position of the thread.
After that, slide the needle (using a parallel direction to the fabric) in the direction of the thread’s tail end. This is supposed to pull the thread’s tail inside the layers. In case the thread’s tail is additionally long, you have the choice of slightly trimming it. Ensure that you have sufficient thread on the tail, just past the thread’s knot to be able to secure the knot.
While using your ‘thimbled’ finger, drive the needle that has thread straight downwards in the quilt layers and ensure it comes out through the other side. You should then use one of the fingers on the other hand to feel if the needle has indeed come through.
Afterwards, use the finger below the quilt for directing the thread and needle back up via the layers up to the top region of the quilt. Push the needle upwards via the layers in the line where your quilt pattern is located (you might be making a quilt ‘in the ditch’ or have come up with a great decoration for your desired quilting pattern).
Immediately the needle has poked the top regions of your quilt, use the thumb for pushing the fabric downwards, away from the needle. This move completes a single stitch.
Go on with this ‘rocking’ quilting movement along the quilt design until the thread is almost 6 inches long. That is when you can knot and cut off the thread.
Thread a second needle and start again. Normally, I use the quilting hoop and whenever I have a hoop-full of quilt, I can move the hoop, then start all over again. In the same way, I normally begin in the middle of the quilt before proceeding towards the sides. In no time you will realize that you have mastered all the tips on how to hand stitch a quilt and you will have the quilt completed.
Related posts: